The cause that causes grinder to shake has a variety of, it is small below write the 3 big reasons that arrange: One of, check n above all. If level of screw of machine tool lower margin does not have mix up, with respect to the resonance that can cause a machine tool. Because add flatness of workshop ground floor sometimes,not be very good, want so through adjusting horizontal screw lets a machine tool reach height of a cobbly, above all we should check lower margin whether is every screw fulfilled reach the designated position to be filled up to lower margin in. Hit next from beginning to end with gradienter, the left and right sides whether level, locking screw. Secondly, if had afore-mentioned action, shake to still was not eliminated, we should be checked whether to come as a result of place of empty of ground floor outer space, if the ground is the floor that terrazzo perhaps lays piece relatively strong, if be cement n, the ground very empty can cause resonance. If where manages,encounter this kind of situation? Go balata hardware store buys glue of rubber of a few black to fill up, ply 6-10 millimeter is controlled, 10 centimeter and lower margin pay bulk dimension is bit more largish go, screw of loose lower margin, fill up rubber rubber mat below mat of horizontal lower margin, can have very big damping effect. Thirdly, if passed afore-mentioned act, shake to still was not eliminated, we are about to check grinding machine arenaceous clang the issue that secures flange with emery wheel. It is emery wheel above all, because the emery wheel quality on market is uneven, emery wheel affects quaky element to have two commonly: The granuality that is emery wheel is inhomogenous, rotate with respect to centre of gravity flabby cause shake; 2 be inside aperture not the standard slants big. For instance requirement of aperture of our grinder flange is 31. 75, and if emery wheel is of 32, mount goes can beating up and down cause shake. We must ask clear norms when buying emery wheel, the proposal buys the emery wheel with good quality. One, poor emery wheel influence machines effect; 2, in machining grinding process crack easily explode easily produce dangerous; 3, result of poor emery wheel balance is bad to can affect the life of grinder main shaft badly. CNC Milling
CNC Machining